Symptomatic treatment of vitreomacular adhesion (VMA).
A proteolytic enzyme that dissolves the protein matrix present in vitreomacular adhesions.
Dissolution of vitreomacular adhesion with improved vision.
Absorption: Minimal absorption
Distribution: Action is primarily local
Metabolism and Excretion: Rapidly degraded following administration
TIME/ACTION PROFILE (VMA resolution)
|Intravitreal||within 1 wk||3 wk||6 mos or more|
- None noted.
Use Cautiously in:
- Lactation: Effects are not know, use caution;
- OB: Use during pregnancy only if clearly needed;
- Pedi: Safety and effectiveness not established.
Adverse Reactions/Side Effects
May be due to procedure
EENT: blurred vision, conjunctival hemorrhage, ↓ visual acuity, eye pain, macular hole, vitreous floaters, retinal edema, anterior chamber cell, cataract, conjunctival hyperemia, dry eye, dyschromatopsia (yellow vision), ↑ intraocular pressure, intraocular inflammation/infection, intraocular hemorrhage, iritis, lens subluxation, macular edema, metamorphopsia (distorted vision), photophobia, photopsia (perceived light flashes), retinal degeneration, retinal detachment, vitreous detachment
* CAPITALS indicate life-threatening.
Underline indicate most frequent.
Intravitreal (Adults) 0.125 mg injected as a single dose.
Solution for intravitreal injection: 0.375 mg/0.3 mL
- Monitor for elevation in intraocular pressure following injection.
- Monitor visual acuity periodically following injection; may lead to decrease in vision.
- Deficient knowledge, related to medication regimen (Patient/Family/Teaching)
- Ocriplasmin must be administered by a qualified physician.
- Intravitreal Remove vial from freezer and allow to thaw for few min at room temperature. Solution is clear and colorless without particles; do not administer solutions that are discolored or contain particulate matter. Withdraw all solution from vial with a 19 gauge needle. Replace needle with 30 gauge needle and expel excess air and solution to 0.1 mL. Discard unused solution. Administer adequate anesthesia and a broad spectrum antibiotic as per protocol. Intravitreal injection is done via aseptic technique. Repeat administration in same eye is not recommended.
- Wait 7 days before treating other eye if necessary.
- Explain procedure for intravitreal injection to patient.
- Advise patient to notify health care professional immediately if signs and symptoms of intraocular inflammation/infection (eye redness, sensitivity to light, eye pain, change in vision) occurs.
- May cause visual changes. Advise patient to avoid driving and other activities requiring good vision until response to medication is known.
- Advise female patient to notify health care professional if pregnancy is planned or suspected or if breastfeeding.
Improved vision in patients with vitreomacular adhesions.
Anesthesia Central is an all-in-one web and mobile solution for treating patients before, during, and after surgery. This collection of drug, procedures and test information is derived from Davis’s Drug, MGH Clinical Anesthesia Procedures, Pocket Guide to Diagnostic Tests, and MEDLINE Journals. Complete Product Information.